This is a very very minor point within an otherwise stellar piece of software:
On the ride graphs the y-axis does not appear to re-scale when looking at a smaller section of the ride like an interval. This sometimes leads to very flat lines because the ymax value is still calibrated to the max of the entire ride rather than the window that is currently visible. When defining a climbing interval this can make it difficult to identify the start of the climb on the altitude graph.
Tx. I actually did that on purpose so zooming in wouldn’t suddenly make small watts look like big watts.
I suppose it would make sense to make the altitude scale behave differently. I have just done that. If anyone raises any objections I will make it configurable.